Analog electronics project

Implement an electrical circuit (audio amplifier) from specifications to practical realization. All design stages will be covered, with the help of PROTEUS software for simulation and LAYOUT realization. The printed circuit board will then be manufactured in the school's laboratory, followed by component installation and final testing.
In a second phase, a 2nd project (sound generator) is to be designed, using all the design methodology independently and with individualized specifications.
All these 2 phases are based on the knowledge of analog electronics acquired in the 1st semester.

General electronics course EA107 and practical work EA108

Methodology applicable to the 2 projects :

Analysis of the specifications for the system to be designed
Definition of the architecture
Design and theoretical calculations of the circuit
Validation by simulation on ISIS (PROTEUS)
Placement routing with ARES (PROTEUS)
Manufacture of the printed circuit
Layout and soldering of the components
Testing and measurements (validation of the specifications)
Report writing

Circuit design for analog electronics on printed circuit boards

Course EA107, TP handout EA108 and documentation on the use of PROTEUS CAD software